Summit Refrigerator SP6DS User Manual

FELIX STORCH, INC.  
SUMMIT APPLIANCE DIVISION®  
SP6DS  
SP6DSSTB  
ALL-REFRIGERATOR  
Three drawer All Refrigerator  
24” wide  
Stainless Steel  
Thank you for purchasing this appliance and for putting your trust in our company. It’s  
designed to refrigerate your fresh foods, while adding elegance to your home.  
 
Important  
To reduce the risk of fire, electrical shock,  
or injury when using your appliance,  
follow these basic precautions:  
WARNING!  
Read all instructions before using the appliance.  
The appliance must be correctly connected to the power supply (See  
Connection to the Power Supply).  
If the food has a strange smell or color throw it away because it is very  
likely that it is spoiled and therefore dangerous to eat.  
Disconnect the appliance from the power supply before repairing and  
cleaning it (only a qualified technician should repair it).  
Do not let children play with this or any other appliance to reduce  
likelihood of injury.  
Disposing of the Worn Out Appliance  
When your appliance finally wears out, dispose of it.  
Before you dispose your old refrigerator or freezer: Take off the  
drawers so that children may not easily climb inside.  
The refrigerating system of the appliance is filled with refrigerant and  
insulating substances which should be separately treated and  
processed. Either have a licensed appliance repair company or dealer  
remove the appliance or call your local recycling office for the  
appropriate disposal.  
For the sake of environmental protection be careful not to damage the  
rear wall of the appliance (the condenser unit or the tubes when  
moving the refrigerator) or any part of the refrigerating system inside  
the appliance.  
Instructions for Use  
3
 
Placing and Installation  
Choosing the Right Place  
Place the appliance in a dry and regularly ventilated room. Allowed ambient  
temperature depends on the model (class) of the appliance and is stated on the  
rating plate of the appliance. This refrigerator is class N.  
Class  
SN (sub-normal)  
N (normal)  
ST (sub-tropical)  
T (tropical)  
Ambient Temperature  
from + 56°F to + 90°F  
from + 62°F to + 90°F  
from + 64°F to +100°F  
from + 64°F to +120°F  
The appliance may be exposed to lower or higher temperatures but only for a  
short period of time and the temperature should never be lower than 41°F.  
Never place the appliance near heat emitting devices (e.g. cooker, radiator, water  
heater or similar devices) and do not expose it to direct sunlight.  
Connection to Power Supply  
Connect this appliance to a 3 prong power supply socket outlet (which has a  
ground terminal). If you only have a two prong outlet have it replaced by a  
qualified technician with an outlet that meets the local codes.  
“DO NOT USE AN EXTENSION CORD.”  
Required nominal voltage and frequency are indicated on the rating plate.  
The connection to the power supply and grounding has to be made according to  
current standards and regulations. The appliance resists temporary voltage  
tolerance from -15 to 10%. Your SP6DS or SP6DSSTB is only for use with 110  
to 120 volts and 60 cycles (standard in USA).  
Removal/Replacing of the Drawers  
To remove the drawers from the refrigerator these directions need to be followed:  
Pull the drawer out towards you completely.  
On both sides of the drawer there are hinges.  
On each hinge there is a black lever.  
The left lever should be pulled up.  
The right lever should be pulled down.  
Both levers should be pulled at the same time while continuing to pull  
out the drawer.  
To reinstall the drawers on the appliance:  
Just simply line up the hinges on the drawer and the hinges on the  
appliance and gently push the drawer in.  
Once lined up close the drawer completely then open again to make  
sure the drawer is on track.  
Instructions for Use  
4
 
Operation Control  
The refrigerator is controlled by the thermostat knob located to the right side of  
the top drawer (it can be seen when the drawer is opened or removed).  
Turn the knob clockwise from the 0 (off) position toward 7 (max) and back  
counter clockwise to 0 (off).  
Temperature Selection  
The settings of the temperature control are from 0 (off) to 7 (max).  
Initially adjust the temperature control setting to 4 (norm), then adjust the  
thermostat to colder or warmer (as needed).  
A higher setting on the knob (towards 7) means colder temperatures in all  
compartments of the appliance. The temperature in the interior of the  
appliance may even drop between 35°-45°F. Use the higher thermostat  
setting only when required or recommended.  
The coolness of the refrigerator depends on how often you open and close  
the drawer.  
To turn the refrigerator off you must turn the thermostat to 0 (off).  
Use  
Storing Fresh Foods  
Foods to be stored in the refrigerator should be properly packed as to  
prevent mixing various moisture degrees and odors (in polyethylene bags  
or sheet, aluminum foil, wax paper, covered containers or bottles).  
Never store any inflammable, volatile or explosive substances.  
An unpleasant odor inside the refrigerator is a sign that something is  
wrong with the food or that your refrigerator needs cleaning. Odors may  
be eliminated or reduced by washing the interior of the refrigerator with a  
mild solution of water and vinegar. We also recommend using activated  
carbon filters or baking soda to clean the air or to neutralize odors.  
If you plan on taking a long trip make sure you remove all perishable food  
before you leave to prevent any odors.  
The interior of the drawers are stainless steel, some cleaners are not  
suitable for stainless steel so read the label of any cleanser before using.  
Do not use abrasive or mildly abrasive cleaners.  
Instructions for Use  
5
 
Maintenance and Cleaning  
Automatic Defrosting of the Refrigerator  
There is no need to defrost the refrigerator, because the ice deposited on the inner  
back wall is automatically defrosted.  
Ice deposits on the inner back wall during compressor operation; later on, when  
the compressor is not operating, ice defrosts any water and drains through the  
outlet in the inner back wall into the drain pan situated above the compressor  
where it evaporates.  
Cleaning the Appliance  
Disconnect the power supply before cleaning the appliance. Do not use coarse or  
aggressive cleaning agents as you can damage the surface.  
Clean the exterior with water and a mild detergent. You may use  
stainless steel cleaners for cleaning the exterior of the appliance  
Remove the detachable drawers; clean them with water and a mild  
liquid detergent. Wash the interior of the appliance with lukewarm  
water, mix one or two spoonfuls of vinegar.  
Attach the drawers once air dried.  
Every now and then wipe the condenser on the rear wall. Use a soft  
non-metal brush or vacuum cleaner.  
Instructions for Use  
6
 
Trouble-Shooting Guide  
During the service of your appliance, you can come across some troubles that in  
most cases result from improper handling of the appliance that can easily be  
eliminated.  
The Appliance Fails to Operate After Connecting to the Power Supply  
Check the supply in the outlet socket and make sure the appliance is  
switched on (thermostat in the operating position).  
Continuous Operation of the Refrigerating System  
The drawer was frequently opened or it was left open too long.  
The drawer is not properly closed (the drawer gasket may be damaged,  
or the drawer may not be seated correctly in its track).  
Perhaps you have overloaded the appliance with too many items.  
The reason may be inadequate ventilation of the compressor and  
condensers (assure adequate air circulation in the rear and wipe off the  
condenser).  
Ice Formation on the Inner Rear Wall  
As long as the defrost water runs to the channel and through the opening to the  
drain pan on the compressor, automatic defrosting of the appliance is assured. In  
case the ice formation on the inner back wall is increased (1/8”), ice should be  
manually defrosted.  
Set the thermostat knob to 0 (OFF) position and leave the drawers open. Never  
use electric devices for defrosting and do not scrape the ice or frost layer with  
sharp objects. After completing defrosting, turn the knob to desired position and  
close the refrigerator drawer.  
The cause of increased ice formation may be one of the following reasons:  
-
-
-
The drawer does not seal well (clean the gasket if it is  
contaminated, or replace it if it is damaged).  
The drawer was frequently opened or it was left opened for too  
long.  
The food stored in the refrigerator was warm.  
Water is Leaking from the Refrigerator  
In case the discharged water outlet is clogged, or the defrost water drips over the  
channel, or water leaks from the refrigerator just clean the clogged opening with a  
plastic straw. Manually defrost the increased ice layer. See “Ice Formation on the  
Inner Back Wall”.  
Instructions for Use  
7
 
Noise  
Cooling in refrigerating-freezing appliances is enabled by the refrigerating system  
with the compressor, this produces noise. How noisy the appliance is depends on  
where it is placed, how it’s used and how old the appliance is.  
During the operation of the compressor, a liquid noise is heard and  
when the compressor is not operating a refrigerant flow is heard. This  
is a normal condition and it has no influence whatsoever on the  
lifetime of the appliance.  
After starting the appliance, the operation of the compressor and the  
refrigerant flow may be louder this does not mean something is wrong  
with the appliance. The noise will reduce gradually, this will not  
affect the lifetime of the appliance.  
Sometimes unusual and strong noises occur which is rather unusual for  
the appliance. This noise is often a consequence of inadequate placing.  
To avoid the noise make sure the appliance is placed and leveled  
firmly on a solid base. Make sure the appliance is not touching the  
wall or kitchen units standing next to it. And always make sure you  
check the accessories in the interior of the appliance; they should be  
placed correctly in their positions. Check the bottles, tins and other  
vessels that might touch each other and rattle.  
This unit contains a rear fan which runs only when the compressor is  
on, and an internal air circulation fan which runs continuously. A  
small fan hum (similar to a computer fan) is normal.  
Before Calling for Service:  
Check the plug, fuse and/or circuit breaker.  
Test the outlet with a lamp  
Be sure the control is not set to 0 (OFF).  
Read the manual, especially the items under the Use and Care sections.  
You may find the answer to your questions.  
If you don’t find the answer to your questions in this manual, find the  
unit model number (on the upper back of the refrigerator) and contact  
your Summit Appliance Dealer.  
٭
 Call Summit Appliance customer service department at 718-893-  
3901.  
Specifications are Subject to Change Without  
Notice.  
8
 
Instructions for Use  
9
 

Shure Headphones E3c User Manual
Sony Cassette Player TC D6C User Manual
Sony Cell Phone 1265 2574 User Manual
Sony MP3 Player D M805 User Manual
Sony PDAs Smartphones PEG SJ33 User Manual
Sony Projector VPL SW125 User Manual
Stamina Products Exercise Bike UX2 User Manual
State Industries Water Heater SRT80 120NE User Manual
Sunbeam Oven 3224 User Manual
Sylvania DVD Player DVL700F User Manual